How to Repair USB Cable

How to Verify Cable Disconnect the USB Head Step by Step

Just share experiences fad remembered this morning with the head of the USB modem is faulty because the wires inside the USB head there are broken . How can i know the break up ? Her initial plug in the USB cable and USB head shake your neck if sometimes can connect sometimes not . Most likely his damage there . Okay , ya immediately wrote to his problem . First before starting , we definitely need the necessary tools .

The equipment required is :

    Damaged USB head
    screwdriver
    pliers
    Cutter
    solder
    tin
    Power glue ( Liquid )


The first step :
Prepare the USB head and observe each part there , in this case I am using an existing USB line at its edge .

The second step :
Prepare Cutter , then cut into the side of the head contained USB line . Cut the direction of the line .

Step three :
Continue cutting the edges of the USB head , to the inside of removable USB

Step four :
Go to the Plat of the USB head min using a small screwdriver to avoid damaging the USB part of the head . Then once the platter is open , loose and separating it from the inside of the USB head . see picture .

Step five :
Clean the parts leftover rubber pieces contained in the white part of the USB . Then open the white part that looks a cable series .

Step six:
Notice the loose cable . Prior to his recall cable arrangement contained in the USB head because this is very important in the next stage of the process . For example, there are on line 1 colors White , Yellow on line 2 , line 3 on the Red and Green on line 4 . Then at it with the USB cable that we want to install . In this case , my white wires are loose . Then slice a bit on the cables so it looks fibers of wire cables .

Step seven:
Prepare the tin solder and then disconnect the cables from USB head and then replaced with new wiring that has been prepared .

Step Eight :
Once finished with his tin solder and , when we close the back of his head the USB , then we wrap again with his plate .

Step nine:
Prepare the power of liquid glue , then glue on the parts of the USB rubber skin . Start of the section near the cable , until the middle part of the USB head .

Step ten :
USB cable is ready for reuse .

This method can be used to correct the Head USB mouse , joystick and so on . Ga cool to play it when I'm suddenly a little head kesenggol its USB direct her to stop playing . Hehe ..